The IC-2820H receives 118-549.995 and 810- 999.990MHz* with dualwatch receiver capability that allows you to receive* two bands simultaneously (including within a single band). Almost all VHF& UHF communications are available to you!

IC-2820H


Quality analog fundamentals,
futuristic digital capability now!

Wideband receiver with simultaneous receive capability

The IC-2820H receives 118-549.995 and 810-999.990MHz* with dualwatch receiver capability that allows you to receive* two bands simultaneously (including within a single band). Almost all VHF& UHF communications are available to you!
* See specifications for receive range coverage.

Diversity receive capability

If you have two antennas, diversity receive* capability is useful for mobile operation where the received signal strength changes continuously. Within a single band, the radio compares signal strength from each antenna and chooses the better signal to maintain good sound and receive quality.
* Available on 127, 136, 146, 375, 440, 500MHz bands in FM, FM-N, DV mode only.

50W output power on both VHF and UHF bands

Dual antenna meterA MOSFET power amplifier provides a powerful 50W on both the 2m and 70cm bands, making this compact rig’s signal travel for miles! Output power is selectable in 3 steps.

User-friendly operation

The large 93×28 mm (321/32 ×13/32 in) full dot matrix display presents an easy-to-read graphical interface, viewable over a wide angle. Push the “Function” button to call up the assigned functions menu on the display. In addition, tuning knobs and buttons for each band are arranged side-by-side, providing intuitive operation.

Symmetric layout and easy-to-read graphical interface

Separate controller from main unit

The controller is separated from the main unit for flexible installation. The controller has magnets on the rear panel, allowing you to attach the controller to the main unit or other metal objects. This makes clean and neat installation easy! A 3.4m separation cable, OPC-1663, and a short cable (10cm), OPC-1712, are included.

522 memory channels

The IC-2820H has a total of 522 memory channels, 500 regular channels, 2 call channels and 20 scan edge channels. Each memory channel stores tone frequency, skip information and so on. The Dynamic Memory Scan (DMS) system divides these memories into 26 groups, A to Z, and provides easy channel selection. Of course, bank scanning is also possible.

Band scope function

The band scope function lets you watch conditions near the receiving frequency and visually assists in finding other stations.

Band scope screen

Other features

  • ±2.5ppm high frequency stability with TCXO unit
  • Green to amber variable display background color
    Green to amber variable display
  • 104×2 DTCS/50 CTCSS tone squelch operation
  • Max. 45 channel/sec. high speed scan capability in programmed scanning mode
  • 9600bps packet terminal, mini DIN (6-pin) connector
  • Long or short squelch delay
  • Automatic attenuator
  • FM narrow capability
  • Sub-band auto mute function
  • 16 DTMF memory channels (24 digits)
  • DTMF pager and code squelch function
  • Auto power off
  • Auto repeater function (USA version only)
  • DTMF remote control function (USA version only)
  • Weather channel with weather alert function (USA and EXP versions only)

D-STAR digital voice + GPS receiver

D-STAR DV mode + GPS receiver

The optional UT-123 provides D-STAR DV mode operation plus GPS receiver capability. Your location information can be sent simultaneously with the digital voice transmission.

Location information exchange

The IC-2820H sends your location information either when the mic PTT switch is pushed, or at a preset interval (5 seconds–30 minutes). When available from a calling station, the IC-2820H displays the distance and direction to the station.

Location information exchange

GPS alarm

The GPS alarm alerts you by beeping when a preprogrammed point is within 500m or 1km range from your location or anyone of preprogrammed points is within a preset square range.

GPS location tracking

When connected to a PC* via the optional RS-232C cable, OPC-1529R, your own or the received location information can be plotted by map software* on a PC.
* Serial port and map software (NMEA 0183) are required.

One touch reply function

The one-touch reply function makes it easy to respond to a calling station instantly. In addition, up to 20 received callsigns are automatically stored as received call records.

Built-in voice recorder and auto reply function

The built-in voice recorder* records an incoming call for up to 30-seconds (approx.), (or 15 sec.× 2 tracks, 10 sec. × 3 tracks). The 10 sec. transmit memory allows you to record your callsign or other message, and also automatically answers when you receive a message.
* Available in DV mode only

Low-speed data communication

When connected to a PC* via the optional data cable, OPC-1529R, the data communication is available simultaneously with a digital voice transmission.
* Serial port and serial communication software are required.

DX communication over the D-STAR system

D-STAR repeaters for 144 and 440MHz are now available, allowing cross-band (144/440/1200 MHz) operation and long distance communication via the Internet over the D-STAR system.
Price: $649.95
Buy Product Online | Visit Store Home
 
Manufactured by Icom


 Other Items from HF Transceivers

  Icom IC-756PROIII - Combination of 32-bit floating point DSP and 24-bit AD/DA converters supports digital processing features, which cannot be achieved with traditional analog processors.
  Kenwood TS-2000 - Truly a marvel of electronic engineering, Kenwood's stylishly new all-mode multibander is packed with top-end features yet compact enough for use at home, in your car, or on a DX'pedition.
  Kenwood TS-480HX - Tailor-made for DX' ing, the new TS-480HX HF transceiver raises the bar on portable performance. Despite its compact dimensions, it delivers an astonishing punch: 200W with a DC 13.8V supply. ($180 coupon included).
  Kenwood TS-480SAT - Sharing virtually all the same powerful features as the TS-480HX is the 100W TS-480SAT, except that it boasts a built-in antenna tuner. ($180 coupon included).
  Kenwood TS-B2000 - Truly a marvel of electronic engineering, Kenwood's stylishly new all-mode multibander is packed with top-end features yet compact enough for use at home, in your car, or on a DX'pedition. This is the computer controlled model.
  Yaesu FT-817ND - The world's first self-contained, battery-powered, Multi-mode Portable Transceiver covering the HF, VHF, and UHF bands!
  Yaesu FT-857D - The FT-857D, the world's smallest HF/VHF/UHF mobile transceiver, provides base station-type performance from an ultra-compact package that's ideal for mobile or external battery portable work. ($50 coupon + Free YSK-857 included).
  Yaesu FT-897D - The FT-897D is a rugged, innovative, multiband, multimode portable transceiver for the amateur radio MF/HF/VHF/UHF bands. ($70 coupon included).
  Icom IC-706MKIIG - Ultra compact HF/6 meter/2 meter/440MHz transceiver with built-in DSP, too! The perfect rig for base OR mobile operations!

Free RMK-706 separation kit ($69.95 value)

Plus Receive a $50 Mail In Rebate!
  Icom IC-718 - Whether you're new to HF or just looking for a capable second rig, the IC-718 is for you. It's simple. Buttons for the functions you use the most are prominent and easy to access.

Plus Receive a $50 Mail In Rebate!
  Icom IC-746PRO - It's like a 32 bit DSP hot rod! This rig'll let you pull signals right out of the mud. SUPERCHARGED performance!

Free PS-125 Power Supply!

 
  Return To Memphis Amateur Electronics, Inc.

 

 
shopping cart
Shopping cart powered by MonsterCommerce ecommerce solutions.